7
English
Instructions for use and disposal
The appliance has been manufactured using high quality materials that can be
reused or recycled. Dispose of the appliance in a suitable waste collection centre.
First use or after a long period of disuse
• Fill the tank with fresh, still water. (Pic.4).
• Plug in the appliance and turn it on.(Pic13 & 14).
• Make sure the lever is closed. (Pic.3).
• Along with the A-B-C keys, the D indicator light will also alternately blink RED.
• Place a large container (at least 250 ml) under the coffee dispensing spout (Pic.9).
• Press one of the buttons A-B-C. Wait for the machine to complete the priming cycle and
fi ll with water. The D indicator light switches off.
NOTE:If the buttons A-B-C and the D indicator light continue to blink after the fi lling
procedure has ended, repeat the steps in previous point.
• When the buttons A-B-C blink at the same time; the machine is warming up.
• When the buttons A-B-C turn on and remain steadily lit, rinse by pressing the C button.
Press the button again to rinse a second time. Wait for the machine to complete the rinse
cycle.
• At the end of this operation, empty out the water from the used capsule drawer (Pic.6).
Turning on the appliance
• Fill the tank with fresh, still water. (Pic.4).
• Turn on the machine by pressing the switch (Pic.14).
• The buttons A-B-C blink at the same time; the machine is warming up. When the
buttons turn on and remain steadily lit, the appliance is ready for use.
General operating indications
DESCALING SIGNAL:
• When the D blinks YELLOW and the machine emits 3 beeps, it is advisable to perform
the descaling cycle. (See section: Descaling)
HEATING:
• The buttons A-B-C blink at the same time.
WHEN THE WATER RUNS OUT DURING OPERATION:
• The water tank is empty when the D indicator light blinks RED and the appliance emits
3 beeps.
• Fill the tank with fresh, still water (Pic.4).
• Press one of the buttons A-B-C. Wait for the machine to complete the priming cycle and
fi ll with water.
• When the buttons A-B-C turn on and remain steadily lit, the appliance is ready for use.
IF THE LEVER IS RAISED:
• If the lever is raised during the delivery of a product (Pic. 1), one can have the emission
of jets of hot water. Risk of burns!
• The
D indicator light
blinks RED and a beep is emitted. The appliance will immediately
stop dispensing.
• Close the lever (Pic.3).
• Press a button A-B-C to reset the alarm.
• The appliance is ready for use.
Comments to this Manuals